*******************************************************************************
KING BRACE  100mph SATELLITE BRACKETS
*******************************************************************************

TESTED TO 115MPH
**************PRO 100mph SATELLITE BRACKETS FOR PRO INSTALLATIONS *************

  VERY HEAVY DUTY GROUND MOUNT TRIPOD GROUND ROOF MOUNT Brace welded KKs  Fedd support arms on Triax 2'' Non-Penetrating Roof Mount BRACE BARS & WELDED Ks BRACE BARS ISS 1m with Purplesat.com feed support arms & back brace  

**************PRO 100mph SATELLITE BRACKETS FOR PRO INSTALLATIONS *************

PRO 100mph BRACKETS FOR BETTER/ FASTER & MORE SOLID SATELLITE INSTALLATIONS.

100mph KING BRACE BRACKETS & ADD-ONS ARE NOT JUST FOR HIGH WIND

EXPOSURE INSTALLATIONS & LONG POLE OVER ROOF INSTALLS

BUT  ARE USED ON ANY JOB TO MAKE A GOOD SOLID JOB IN ANY INSTALLATION

& A SOLID JOB ALLOWS FAR BETTER ALIGNMENT FOR FIXED OR MOTORISED INSTALLS!
 
*****************************************************************************************
KING BRACE WELDED  K & K  100mph SATELLITE  BRACKETS 
*****************************************************************************************


1-1m motorised low down = 50+e/wBrace welded KKs

*******************************************************************************
KING BRACE WELDED  K & K  100mph SATELLITE  BRACKETS 
*******************************************************************************

These are not standard aerial T & K brackets but are very uniform, solid & have DOUBLE Ks with extra bracing & welded joints for ROCK SOLID satellite installations .....  far more solid than waving aerial T & K brackets on long poles incorrectly used by so many for satellite installation.

SAVE TIME & MONEY no need to fit multiple T & K brackets or over long poles down walls

Designed especially for long pole over roof installations & rock solid motorised satellite installations & more solid long pole large aerial installations. 

POLE SIZES ...........  50mm 60mm 70mm 100mm.

2 x 12" braced 'K's...... £48   £52    £55       £65
2 x 18" braced 'K's.......£56   £59    £65       £75
2 x 24" braced 'K's.......£74   £79    £85       £99
2 x 36" braced 'K's.......£89   £95    £100     £125

Can be used in conjunction with our wall brace bars, our brace welded double K brackets can be used for  dishes installed on walls/ exposed sites or over gutter & roof height providing there is suitable bracing points for adequate lateral bracing- thus reducing the excessive weight of some bracket & pole designs that can add excessive weight & stress before the dish is installed & put more stress on a smaller area of bricks & mortar.

For other K bracket sizes or multiples (3 off etc) ...
£Ask


*******************************************************************************
KING BRACE  100mph GROUND MOUNTS 
*******************************************************************************


VERY HEAVY DUTY GROUND MOUNT

*******************************************************************************
KING BRACE  100mph GROUND MOUNTS 
*******************************************************************************


Very heavy duty ground mounts that can be bolted into concrete or paving for a ROCK SOLID no sway 100mph ground mounts for Satellite dishes.

POLE LENGTH / DIA/ MAX DISH SIZE / PRICE

1000mm/ 50mm 1.2m....£69
1200mm/ 50mm 1.2m....£89
1400/ 75mm 1.8m.........£159

1600mm/ 100mm 2.4m ..£249

2400mm... 3000mm pole lengths & for
Custom ground mounts for larger dishes / higher pole mounts....
£Ask

*************************************************************
KING BRACE 100mph  GROUND OR ROOF TRIPOD
*************************************************************



TRIPOD GROUND ROOF MOUNT  TRIPOD GROUND-ROOF MOUNT TRIPOD GROUND-ROOF MOUNT

Very heavy duty TRIPOD ground or penetrating roof mount that can be bolted into concrete or paving patios, for a ROCK SOLID no sway 100mph ground mounts for Satellite dishes. Includes brace bars.

POLE LENGTH / DIA/ MAX DISH SIZE / PRICE

1.2m/ 50mm dia/ up to  1.2m...... £99
1.4m/ 75mm/ up to 1.8m ............£159
1.6m/ 100mm/ up to 2.4m...........£249

Other sizes for 3m 4m 5m dishes etc..... Ask

********************************************************************************
KING BRACE 100mph  3"  4"   6"  &  8" FLANGED GROUND MOUNT
********************************************************************************


4 inch flanged ground mount  flanged ground mount diag II
example 6"/150mm flanged ground mount      Diag 1a showing underground & above ground & flush when removed.

CHANNEL MASTER 2.4 TWIN AXIS 4 BAND GROUNDS MOUNTED  underground screw piles
*****************************************************************************************
KING BRACE 100mph  3" 4" /6" / 8" FLANGED GROUND MOUNT
*****************************************************************************************

One of our custom ground mounts that can support 3m-4m ground mounted satellite poles holding 1m-1.1m, 1.2m 1.8m 2.4m 3m 3.6m 4m dishes in 100+mph winds & 125mph survival.
The flanged fitting means it can be adjusted at the base for level at any time if there is any movement/ subsidence. It also means that the pole can be removed completely leaving a flush base that can be completely hidden without the 20mm threaded bars protruding above the surface in the case of King Posts.The concreted base is hidden from sight.

The pole starts with 3" 4" 6" or 8"  heavy wall insurance welded schedule 80 (or 10mm wall) high tensile pipe for the 1st meter or 2m*. Then followed by 3"/4" or 6" schedule 40 (or 5-6mm wall) and the final meter (for a 3m installation) reducing to a 2" shed 80 (5mm wall) pipe for 1m or 3" for 1.8m or 4" for 2.4m. In some domestic locations in large grounds  these have been dressed  with Victorian lantern top &/or flower hanging baskets etc... £/$ prices for these mounts are on request & custom made.

*********************************************************************************************
KING BRACE  45 degree T & K  100mph SATELLITE  BRACKETS 
*********************************************************************************************

45 degree T & Ks  45_degree_brackets___dish_5aaa.jpg
*******************************************************************************
KING BRACE  45 degree T & K  100mph SATELLITE  BRACKETS 
*******************************************************************************


FOR 45 DEGREE ANGLES OFF OUTSIDE CORNERS & CHIMNEYS.

Get that satellite or motorised arc in difficult situations/ awkward angles / round corners & low off chimneys often avoiding needing to go over gutters.
If used on chimneys 45 degree T & Ks can get the full arc, especially when the roof line is north/south & still keep the dish below 60cm above the roof line as in the above example which still achieved satellites to over 50 degrees east & west and over 40 satellites in a large busy city.

As with any installation, the engineer should inspect the chimney and advise structural deep pointing, rebuild, relaying as many chimneys can suffer more from poor brickwork & mortar due to corrosive chemicals in the flue gases combined with a chimney's greater exposure to the elements. You should use multiple chimney strapping kits where deemed appropriate & adhere to planning & building recommendations at all times.

SIZES - 

18" ....£56
24" .....£68
36" ....£74
above 36"...
£Ask

double corner bracket 2
Very heavy duty single piece corner bracket with bolt & lashing fittings for corner walls & large chimneys*.

As with any installation, the engineer should inspect the chimney and advise structural deep pointing, rebuild, relaying as many chimneys can suffer more from poor brickwork & mortar due to corrosive chemicals in the flue gases combined with a chimney's greater exposure to the elements. You should use multiple chimney strapping kits where deemed appropriate & adhere to planning & building recommendations at all times.

24" [20"] stand off available ...............
£94.99



*******************************************************************************
KING BRACE  BRACE BARS 100mph SATELLITE  BRACKETS 

*******************************************************************************


BRACE BARS & WELDED Ks BRACE BARS Balcony mounted brackets - twin braced Ts & concreted base.

*******************************************************************************
KING BRACE  BRACE BARS 100mph SATELLITE  BRACKETS  
*******************************************************************************
 


The bolt on .. ADD ON BRACE BARS that fit most wall brackets, T & Ks and ground mounts.

Add Brace bars for very SOLID Satellite Installations- especially designed for long pole over roof installs & exposed locations & save the need to use multiple T & Ks& K Ks & thicker heavier poles.
Various standard lengths - just bolt on & fix to wall or ground at selectable angles .......

To fit 12" T & Ks or Brackets with 8"-10" standoffs............£5.89
To fit 18" T & Ks or Brackets with 12"-16" standoffs..........£6.89
To fit 24" T & Ks or Brackets with 16"-30" standoffs..........£9.89
To fit 36" T & ks or Brackets with 30""-34"" standoffs.......£12.99
*state if you require holes at 90 degrees to each other or standard will be supplied.


*****************************************************************************
KING BRACE 100mph  HEAVY DUTY SWAN NECK OFFSET POLES
*****************************************************************************


45 degree swan neck

50mm O/D 5mm wall high tensile pipe welded offset 'Swan Necks'- made to measure @ any angle to get those satellites in hard to position situations ..... 3m x 500mm offset from £69 delivered    others...£.. Ask
 


*******************************************************************************
KING BRACE  100mph FEED SUPPORT ARM KITS 
*******************************************************************************


ADD ON Feed Support Arms KITS - fit most dishes...
Makes weak dishes perform like a Channel Master & stand up to strong wind/ improves dB performance & makes up for weaker LNB / feed arms.


ISS 1m with Purplesat.com feed support arms & back brace  Fedd support arms on Triax

*******************************************************************************
KING BRACE  100mph FEED SUPPORT ARM KITS 
*******************************************************************************


FEED SUPPORT ARM DIag 1e


*******************************************************************************
KING BRACE  100mph FEED SUPPORT ARM KITS 
*******************************************************************************


King Brace feed support arms greatly increase the rigidity of any modern dish.

<60cm.... £18.99
61- 84cm.... £24.99
85-1.1cm.... £32.99
Above 1.1 & custom ..... £Ask

__________________________________________________
*****************************************************************************************
KING BRACE   TWIN AXIS  100mph  POLARMOUNTs 
*****************************************************************************************

1m-1.8m polarmount
Custom & off the shelf single or twin axis Polarmounts for 90cm 1m 1.2m 1.5m 1.8m
£.... Ask.

Channel Master Twin Axis Polarmount 1a    
Custom & off the shelf single or twin axis Polarmounts 1.8m 2.4m 3m 3.7m 4m 5m  
£....Ask

BCS Satellite Engineering TWIN AXIS polarmount for 1.8m 2.4m 3m 3.7m 4m 5m motorised satellite dishes for broadcast VSAT / pub football & sport & very high end satellite enthusiasts - the best in the world
Coded/ Insurance welding option/ self lube bearings & heavy wall steel construction.
£..... Ask.

*******************************************************************************
KING BRACE  UNIVERSAL MULTI LNB ARMS  
*******************************************************************************


ONE OF THE MOST ADJUSTABLE DESIGNS ON THE MARKET FOR BETTER RESULTS

  multi lnb bracket vertical
SIDE BY SIDE OR ON TOP OF EACH OTHER (For inclined actuator polarmounts)

 KING BRACE  UNIVERSAL MULTI LNB ARMS 

Our professionally designed precision  UNIVERSAL MULTI LNB ARMS  allow you to acheive far better position & focus for multi LNB setups than standard off the shelf multi LNB arms/ bars to help get the best positioning & focus for difficult weak satellites &/or difficult satellites at the extreme edge.
Designed to fit most LNB / feed arm dimensions, tube or box section including Triax, Gibertini, Orbital, ISS, Fortec Star, Channel Master-Andrews & Prodelin designs (single or 3 leg versions), Lenson Heath,  Silvertech, Alsat, Penta etc.

1 added LNB £19.95
2 added LNBs £27.45
3 added LNBs £34.85
for 4 or more added LNBs or custom work ..... £Ask 


For any bracket enquiries including bulk trade enquiries & custom bracket work.. 


Contact purplesat.com for any queries regarding satellite or aerial & HD/3D installations.
TEL: 01625 615379
TEL: 07931 846757
International
TEL: 00 44 1625 615379